Philtec logo art
Our 32nd Year Logo

Products

linkedin button facebook button Find Philtec Videos on YouTube

Amplifier Options

Photo of Vacuum Hardware
Option Code Feature
A (Analog) Provides temperature stabilized electronics for low drift and high accuracy.
A (Digital) Provides two additional 12 bit analog outputs for muDMS sensors with USB output.
G1 Additional output, DC coupled with 10x gain and adjustable DC offset.
G2 Additional output, AC coupled with 10x gain.
H1 High frequency amplifier for D models up to 200 KHz bandwidth.
H2 High frequency amplifier for D models above 200 KHz to 1 MHZ bandwidth.
H3 Provides RC models with a high bandwidth amplifier,DC - 200 KHz.Bandwidths up to 350 KHz can be specified.
+H1 Additional output for D models with bandwidths up to 200 KHz.
+H2 Additional output for D models with bandwidths exceeding 200 KHz up to 1 MHz.
+H3 Additional high frequency output.
L Low frequency amplifier (< 20 KHz), 100 Hz STD.
+L Additional output with low frequency bandwidth (< 20 KHz), 100 Hz STD.
M Digital display - DC volts.
N Low Noise Amplifier - The amplifier is optimized to operate with highly reflective targets only. This cuts noise floor in half, thereby doubling resolution (For RC sensors only)
O Provides an adjustable 0 to -4 VDC offset control. This feature is used to eliminate the DC offset from the sensor output, thereby increasing readout resolution.
P Polynomial curve fit to specified calculation range.
Q Connectorized AC/DC power adaptor and BNC output.
R1 AMBIENT LIGHT REJECTION - STANDARD UNITS ARE SENSITIVE TO BROADBAND LIGHT FROM 400 - 1100 nm. WITH OPTION R1, INCOMING LIGHT IS BLOCKED FROM <800 to >900 nm.
R2 BLUE LIGHT FILTER, 470 nm ±50 nm.
V Provides sensor amplifier with 0 - 10 volt output.
Z Additional Output with Linear Range Spanning 0 - 5 volts